-
Out of stockYamaha RD250/350 Wiring Harness. Reproduction wiring harness for the Yamaha RD250/350 (all years). Due to the high cost of reproduction harnesses and originals being discontinued, Economy Cycle commissioned a manufacturer to do a run of harnesses for the 250/350. All wiring colors and connectors are the same as stock and is a direct fit replacment, but varies from original harness in terms of materials used for loom, color of plastic connectors, and other minor differences, etc. Note: This harness does not work with the later Euro 250's (that looked like 400's with the coffin tank).
-
Out of stockYamaha RD400 Wiring Harness. Reproduction wiring harness for the Yamaha RD400 (1976-1977). Due to the high cost of reproduction harnesses and originals being discontinued, Economy Cycle commissioned a manufacturer to do a run of harnesses for the 400. All wiring colors and connectors are the same as stock and is a direct fit replacement, but varies from original harness in terms of materials used for loom, color of plastic connectors, and other minor differences, etc. Note: 76/77 use the same harness.
-
Electrical Connector Cover (under side cover for generator/rec/regulator wires) Replaces OEM #256-82599-00-00, similar to original.
-
Yamaha Gauge Bulb Socket/Harness, replaces Yamaha part no.s 360-83131-03 & 360-83131-07 & others. High quality reproduction suitable for Yamaha RDs, R5/DS7 & others. Sold each. Avaiable in singles/doubles
-
Yamaha RD, RZ, R5, TZ - Generator Wiring Grommet. Reproduction part no longer available from Yamaha. Excellent high quality replacment part, chemical resistant, creates a dust and water tight seal. These can be used with the stock wiring or when replacing the ignition with the Powerdyanmo system.
-
Yamaha RD250 Front Brake Switch part no. 395-83980-09-00. also fits RD60,RD125, RD200,RD125,RD200,DT's.
-
Yamaha RD250/350 (all) Tail Light Wiring Harness. Reproduction.
-
Yamaha RD250/350/400 Battery Wiring Harness Yamaha RD400 (all years) Battery Wiring Harness. This is the short harness that connects to your battery +/- with ring terminals on one end, bullets on the other. This harness is made with 14 gauge primary wire, 6mm ring terminals suitable for most batteries and standard yamaha 4mm bullet connectors (Red female/Black male) and black loom. Includes rubber block cover for + battery terminal. Reproduction part as close to the original as possible. Yamaha RD250/350 (all years) Battery Wiring Harness. This is the short harness that connects to your battery +/- with ring terminals on one end, bullet/ring on the other. This harness is made with 14 gauge primary wire, 6mm ring terminals suitable for most batteries and standard yamaha 4mm bullet connectors (Red female/Black male) and black loom. Includes rubber block cover for + battery terminal. Reproduction part as close to the original as possible.
-
Yamaha RD400/RZ350 Front Brake Switch. Reproduction Part. replaces OEM 26H-83980-00-00 and 1A0-83980-30-00
