Electrical / Ignitions / Lights

//Electrical / Ignitions / Lights
  • Zeeltronic PCDI10VT CDI for Yamaha RZ350. Programmable CDI/Ignition and Power Valve controller. This unit replaces the stock RZ350 CDI and Powervalve controller. Ability to program your own ignition/power valve curves or use any of 5 preloaded ignition curves (switching between curves and programming your own curve requires handheld or USB programmer, sold separately). Includes 3 stage rev limiter, 20K rev ceiling, shift light output, shift kill for quick shift, electronic tach output. Store and load 2 ignition maps and 5 powervalve curves. Comes with instructions and wiring diagrams. 24 mos. warranty. Sample picture. Note: This item is not eligible for discount or special promotions. We stronhly recommend purchasing the programmer as there are settings that need to be entered/changed, power valves, static timing, rev limiter etc).
  • Dynatek Ignition Coil - RZ350. Replacement ignition coil for RZ350/RD350LC. Dynatek miniature series .5ohm coil. Dual outputs. 40,000 volts vs. stock coil @25,000 volts. Includes plug caps. RZ coils are no longer available from Yamaha. This is a universal coil, not an exact duplicate of the RZ coil and not a direct bolt on; however, we offer an easy hardware/wiring installation kit that allows mounting of this coil in the stock location. Hardware/Wiring kit is offered here on the site in the RZ coils category. Otheriwise, you will need to determine a mounting method. Sold each - one coil w/dual outputs
  • This unit can be used to replace the stock RZ350 CDI and no programming is required. Comes pre-programmed with igntion curve similar to stock ignition curve for the RZ350 (US/Canadian/Euro Models). Comes with instructions and wiring diagrams. 24 mos. Warranty. Unit comes with pig-tail wire ends and will require solder or crimped connections to RZ harness. Bullet connector kits and connector blocks sold here on the site suitable for this purpose. Note: Programmer can be added for ability to program custom ignition curve. Note: This unit is also ideally suited for aftermarket non-power valve cylinders like Athena, Trinity, CPI.
  • Dynatek High Performance Spark Plug Wires. 8mm suppression spark plug wire set, great for use with our Dynatek coil. Highest grade graphite suppression core to reduce electrical noise and increase engine performance. Two wires, 48" length (cut to length for your specific application). Gray outer cover, includes insulators as pictured.
  • Zeeltronic PCDI10T CDI for Yamaha RZ350. Programmable CDI/Ignition controller. This unit replaces the stock RZ350 CDI. Ability to program your own ignition valve curves or use any of 5 preloaded ignition curves (programming your own curve requires handheld or USB programmer, sold separately). Includes 3 stage rev limiter, 20K rev ceiling, shift light output, shift kill for quick shift, electronic tach output. Store and load 2 ignition maps and 5 powervalve curves. Comes with instructions and wiring diagrmams. 24 mos. warranty. Note: This unit replaced the stock RZ CDI. It comes pre-programmed with stock curves and can be installed and run without programming. Note: This unit is also ideally suited for aftermarket non-power valve cylinders like Athena, Trinity, CPI.
  • Dynatek Ignition Coil Hardware/Wiring Installation Kit. This kit allows mounting of our Dyna coil for the RZ350 in the stock location. Includes all hardware, nuts, bolts, spacers, sub wiring harness and complete installation instructions with pictures included with kit. Bolt on kit, no drilling or mods required. Note: This is for installation on 1984-1985 USA models of the RZ350 and also fits the Australian RZ350 1983-1985. We have not installed this kit on other models of the RZ350 from other countries. Does not include plug wires, also sold here on the site under the coils category. Click on pics to enlarge (Dyna coil mounted with this Kit on an RZ350)   2Main1RZCoil   1Main1RZCoilAlt
  • Dynatek Ignition Coil Kit - RZ350 Includes:
    • Dynatek Ignition Coil - RZ350. Replacement ignition coil for RZ350/RD350LC. Dynatek miniature series .5ohm coil. Dual outputs. 40,000 volts vs. stock coil @25,000 volts. Includes plug caps and crimp connectors. RZ coils are no longer available from Yamaha.
    • Dynatek Spark Plug Wires - Dynatek High Performance Spark Plug Wires. 8mm suppression spark plug wire set, great for use with our Dynatek coil. Highest grade graphite suppression core to reduce electrical noise and increase engine performance. Two wires, 48″ length (cut to length for your specific application). Gray outer cover, includes insulators as pictured.
    • RZ350 Hardware/Wiring Installation Kit - This kit allows easy mounting of our Dyna coil in the stock coil location. Includes all hardware, nuts, bolts, spacers, a sub wiring harness and complete installation instructions with pictures. Bolt on kit, no drilling or mods required. Note: This is for installation on 1984-1985 USA models of the RZ350 and also fits the Australian RZ350 1983-1985. We have not installed this kit on other models of the RZ350 from other countries.
  • The original round pin type connector blocks Yamaha used are no longer available. We've had lost of requests for a connector block kit to replace the original ones. This kit includes a 3,4,5 and 6 position connector blocks, both male and female sides, and 6.3mm brass spade connectors both male and female. You will use all the connector blocks with the PCDI-10VT, the PDCI-10T will not use the 6 pin connector blocks. We include diagrams showing the placement of the connector blocks and cooresponding colored wires. We recommend having the following tools to replace the connectors: You will need a crimping tool: Crimping Tool and preferalby a terminal extraction tool: Terminal Extraction Tool  
  • 12V Horn by K&S - available in Chrome or Black - Very similar to original RD horn size, shape and mount. 110-120 db
  • Out of stock
    1984-1985 RZ350 (USA) Wiring Harness 48H-82590-50-00 Reproduction Harness Reproduction replacement main wiring harness for the US RZ350 (1984-1985). Includes updated fuse box with modern mini-spade type fuses. Connector blocks included for connections to CDI and Catalytic converters as they varied in production years.
  • 35V Electrolytic Capacitor. This capacitor can be used to create a battery eliminator which will work on most bikes with CDI ignitions. Instructions for making this capacitor into a battery eliminator can be easily found on the internet, please do not contact us for instructions, this is intended for the do it your selfer with the electrical knowledge and tools necessary to create and wire the eliminator. We also sell a pre-made capacitor battery eliminator here on the site by Zeeltronic. This does not work with bikes with points/condensor/magneto type ignitions. For instance, this eliminator will work with the RZ350 but will work will not work with the stock RD350/400 ignition. Not recommended for use with the Powerdynamo ignition system.
  • Battery Eliminator by Zeeltronic. Battery eliminator is an electrolyte capacitor (30000-45000uF/25V) and works on most bikes with CDI ignitions. This does not work with bikes with points/condensor/magneto type ignitions. For instance, this eliminator will work with the RZ350 but will not work with the stock RD350/400 ignition. Not recommend for use with the Powerdynamo ignition.
  • Battery Lead / Terminal Cover. Used to cover the battery terminal leads.
  • Degree Wheel by Motion Pro. Manufactured from .052 thick aluminum with a 6.75 outside diameter and a 6mm center hole. Black anodized finish with easy-to-read numbers. Check or set ignition and/or cam timing. Can be used on 2- and 4-stroke engines.
  • We designed these new kits with RD enthusiasts in mind and includes the following specs / features
    • Works with the engine in the frame (most dial gauges are too large and won't fit in the RD due to the frame rails sitting just above the heads)
    • Metric Gauge - no need to convert from SAE and one less chance to make a mistake when converting
    • Increments:
      • 10mm stroke 1/100mm graduation
      • Big hand sweeps 1 mm
      • Smal hand in .10 mm increments
    • 10, 12, & 14mm adapters makes this kit suitable for most 2 strokes
    • 2 Extensions
  • Test the integrity and strength of your ignition system. Spark gap is adjustable from 0 to 10mm. Measure spark strength. Will test the ignition on most motorcycles, watercraft, ATVs & snowmobiles
  • Maintenance Free Sealed Battery for Yamaha R5, DS7 RD250/350/400, RD350LC, RZ35350 From Parts Unlimited. **Batteries will ship via UPS - Provide a street address for shipping - UPS will not ship to a PO Box**. Battery includes acid pack. Note this battery is slightly smaller than stock battery. *additional shipping costs apply to this item, calculated at checkout.
  • Timing kit for inspection and adjustment of ignition timing; gauge face size 1 1/2". Comes with adapter for air-cooled 2 strokes. Although this is an excellent gauge, we do not recommend it for the RD250/350/400/R5/DS7 as there isn't enough clearance to use the gauge with the engine installed in the frame. For the RD250/350/400/R5/DS7 or any bike with minimal clearance between the frame and spark plug, we recommend the Economy Cycle Dial Gauge made specifically for RD and Yamaha twins, which can be found here Economy Cycle Dial Gauge
  • NGK Iridium Spark Plug RZ350. (BR8EIX Stock). The ultimate in the evolution of spark plug technology and performance from the industry leader. The iridium electrode is 25% smaller than a platinum electrode, and it’s just 1/4 the size of a conventional nickel electrode. Ultra-small-diameter center electrode reduces voltage requirement and extends ignition system life. New metal shell plating has enhanced anti-corrosion qualities. Choose heat range, quantity, and click add to cart.
  • ***NOTE*** B8ES has been discontinued by NGK, you can substitute BR8ES for the RD400, will work fine. ***NOTE*** B8HS has been discontinued by NGK, you can substitute BR8HS for the RD350, will work fine. The NGK Standard Spark Plug is manufactured to enhance the performance of the vehicle. It is constructed from durable material that is corrosion and abrasion resistant. The Spark plug insulators are made of 99 percent pure alumina silicate, allowing for longer insulator noses for reduced fouling. This Spark plug features a triple gasket sealing process that eliminates fuel leakage. It also includes a solid copper core that provides superior heat dissipation and conductivity. This Spark plug has resistor that is produced with a glass and carbon mixture, which is fired to ensure superior performance and durability. It has corrugated ribs that prevent flash over and cold rolled threads to inhibit damage to the cylinder head. Choose spark plug and click add to cart.
  • Parts Unlimited Conventional Battery, stock replacement for Yamaha RZ350. Parts Unlimited premium-quality. Parts Unlimited batteries are a high-quality, low-cost alternative to OEM battery replacement Built to the same exacting specifications and quality control standards as top brand-name Japanese batteries Rugged and reliable starting power for your machine **Batteries will ship via UPS - Provide a street address for shipping - UPS will not ship to a PO Box**. Battery does not include acid. *additional shipping costs apply to this item, calculated at checkout.
  • USB Programmer for PC/Laptop for use with Zeeltronic PCDI10V CDI for Yamaha RZ350. Includes USB adapter and cords for connection to computer/PCDI10V and easy to use software. Note: This item not eligible for discount or special promotions.
  • RZ350 Battery Strap (all years/models) OEM Yamaha part.
  • Ready to run system - bolt on - Racing ignition by Powerdynamo. Engineered and manufactured with high quality components made for the extreme demands of racing. High-speed (up to 22.000rpm) magnet based solid state ignition for sports purposes. At 18.000rpm (i.e. 36.000 sparks/min) still 25kV output. (3.000-8.000rpm = 40kV, see diagram). Diameter of rotor is 59mm, rotor weight 180 gramms. This ignition is for racing, no charging component, no lighting capabilities.
    • note: Total loss racing ignition system  - requires starter roller or bump start, does NOT work with kick starter
  • Spark Plug Wrench - 3 Way 14mm/12mm/10mm. Sold each.
  • Wiring Diagrams - 11" x 17"  - Laminated, Full Color
  • Wiring Diagrams - 8.5" x 11" - Laminated, Full Color
  • Yamaha RD400/RZ350 Front Brake Switch. Reproduction Part. replaces OEM 26H-83980-00-00 and 1A0-83980-30-00
  • Yamaha RZ350 (1984-85 USA) Regulator / Rectifier. Replacement regulator/rectifier built to OEM specs. One year warranty. Same OEM plug ends.
  • amaha RZ350 Tail Light - Reproduction, replaces OEM part no. 31L-84540-31-00 & 33E-84540-60-00. High Quality Reproduction. 
  • Yuasa Maintenance Free Sealed Batteries for Yamaha R5, DS7 RD250/350/400, RD350LC, RZ350. Yuasa is a premium Japanese battery. Special absorbed-glass mat battery eliminates water loss, permitting the battery to be permanently sealed once it is filled with acid; Acid pack included. Truly the world’s finest “install it and forget it” motorcycle battery **Batteries will ship via UPS - Provide a street address for shipping - UPS will not ship to a PO Box**. Note this battery is slightly smaller than original stock battery. *additional shipping costs apply to this item, calculated at checkout.
  • Yuasa Premium Conventional Battery for Yamaha RZ350. Great OEM replacement. Only Yuasa has the YuMiCRON, the most powerful lead-acid battery of its size, which appears as original equipment on more and more big bikes. **Batteries will ship via UPS - Provide a street address for shipping - UPS will not ship to a PO Box**. Battery does not include acid. *additional shipping costs apply to this item, calculated at checkout.
  • Zeeltronic Handheld Programmer (for use with VCDI04 and PCDI10V. Handhled programmer allows custom programming of Zeeltronic ignition controller/CDI. Real time readout of revs and timing angle. Note: This item not eligible for discount or special prmotions.
  • Zeeltronic Ignition Map switch. Handlebar mounted ignition map switch lets you change ignition curves on the fly. Works with Zeeltronic ignition controllers. Note: Not for use with VDCI-04 or CDIRZ4.